Register

NIELIT 2016 DEC Scientist B (CS) - Section B: 11

• recategorized by
1,584 views
0 votes
0 votes

A sinusoidal signal is analog signal, because:

  1. it can have a number of values between the negative and positive peaks
  2. it is negative for one half cycle
  3. it is positive for one half cycle
  4. it has positive as well as negative values
• recategorized by
User Avatar

1 Answer

Voting & Accepting an answer helps improve the community
Answer:
← PreviousNext →
Next in category →

Related questions

0 votes
0 votes
1 answer
1
admin asked Mar 31, 2020
2,476 views
NIELIT 2016 DEC Scientist B (CS) - Section B: 10
The noise due to random behavior of charge carriers is: Partition noise Industrial noise Shot noise Flicker noise
The noise due to random behavior of charge carriers is:Partition noiseIndustrial noiseShot noiseFlicker noise
User Avatar
0 votes
0 votes
1 answer
2
admin asked Mar 31, 2020
939 views
NIELIT 2016 DEC Scientist B (CS) - Section B: 17
$T1$ carrier system is used: For delta modulation Industrial noise For frequency modulated signals None of the above
$T1$ carrier system is used:For delta modulationIndustrial noiseFor frequency modulated signalsNone of the above
User Avatar
0 votes
0 votes
1 answer
3
admin asked Mar 31, 2020
9,925 views
NIELIT 2016 DEC Scientist B (CS) - Section B: 18
Which of the following is not defined in a good Software Requirement Specification(SRS) document? Functional requirement Goals of implementation Nonfunctional requirement Algorithm for software implementation
Which of the following is not defined in a good Software Requirement Specification(SRS) document?Functional requirementGoals of implementationNonfunctional requirementAlg...
User Avatar
0 votes
0 votes
1 answer
4
admin asked Mar 31, 2020
1,595 views
NIELIT 2016 DEC Scientist B (CS) - Section B: 25
A low pass filter is Passes the frequencies lower than the specified cut off frequency Used to recover signal from sampled signal Rejects higher frequencies All of the above
A low pass filter isPasses the frequencies lower than the specified cut off frequencyUsed to recover signal from sampled signalRejects higher frequenciesAll of the above
User Avatar
Link Copied!