Login
Register
Dark Mode
Brightness
Profile
Edit Profile
Messages
My favorites
My Updates
Logout
Recent questions tagged integrated-circuits
0
votes
0
answers
1
GATE CSE 1988 | Question: 1ii
Assuming ideal diodes, the voltage at $V_0$ for circuit in the below figure is _______ (Express the voltage in terms of x, y and z)
Assuming ideal diodes, the voltage at $V_0$ for circuit in the below figure is _______ (Express the voltage in terms of x, y and z)
go_editor
421
views
go_editor
asked
Dec 10, 2016
Integrated Circuits
gate1988
integrated-circuits
out-of-gate-syllabus
+
–
0
votes
0
answers
2
GATE CSE 1987 | Question: 15a
Fig. below shows the circuit diagram of a wien bridge oscillator using an op-amp. The frequency of oscillation is given by $f= 1/2 \pi CR$. To have the system oscillate the ratio $R_{2}/R_{1}$ should be $0.5$ $29$ $2$ Any value
Fig. below shows the circuit diagram of a wien bridge oscillator using an op-amp.The frequency of oscillation is given by $f= 1/2 \pi CR$. To have the system oscillate th...
makhdoom ghaya
922
views
makhdoom ghaya
asked
Nov 15, 2016
Integrated Circuits
gate1987
integrated-circuits
out-of-gate-syllabus
+
–
1
votes
0
answers
3
GATE CSE 1987 | Question: 1-I
The most satisfactory LED driver circuit using a TTL gate is:
The most satisfactory LED driver circuit using a TTL gate is:
makhdoom ghaya
589
views
makhdoom ghaya
asked
Nov 7, 2016
Integrated Circuits
gate1987
non-gate
integrated-circuits
out-of-gate-syllabus
+
–
1
votes
1
answer
4
UGC NET CSE | December 2011 | Part 2 | Question: 32
A chip having $150$ gates will be classified as SSI MSI LSI VLSI
A chip having $150$ gates will be classified asSSIMSILSIVLSI
makhdoom ghaya
787
views
makhdoom ghaya
asked
Aug 19, 2016
CO and Architecture
ugcnetcse-dec2011-paper2
co-and-architecture
integrated-circuits
+
–
2
votes
1
answer
5
UGC NET CSE | June 2012 | Part 2 | Question: 36
Which of the following logic families is well suited for high-speed operations? TTL ECL MOS CMOS
Which of the following logic families is well suited for high-speed operations?TTLECLMOSCMOS
go_editor
1.5k
views
go_editor
asked
Jul 5, 2016
Integrated Circuits
non-gate
integrated-circuits
ugcnetcse-june2012-paper2
+
–
4
votes
1
answer
6
ISRO2014-46
If the maximum output voltage of a DAC is $V$ volts and if the resolution is $R$ bits then the weight of the most significant bit is ________ $V/(2^R -1)$ $(2^{R-1}).V/(2^R-1)$ $(2^{R-1}).V$ $V/(2^{R-1})$
If the maximum output voltage of a DAC is $V$ volts and if the resolution is $R$ bits then the weight of the most significant bit is ________$V/(2^R -1)$$(2^{R-1}).V/(2^R...
go_editor
3.2k
views
go_editor
asked
Jul 1, 2016
Integrated Circuits
isro2014
non-gate
integrated-circuits
+
–
3
votes
2
answers
7
ISRO2011-80
Logic family popular for low power dissipation CMOS ECL TTL DTL
Logic family popular for low power dissipationCMOSECLTTLDTL
go_editor
3.7k
views
go_editor
asked
Jun 24, 2016
Integrated Circuits
isro2011
non-gate
integrated-circuits
+
–
4
votes
3
answers
8
ISRO2008-21
The advantage of MOS devices over bipolar devices is that it allows higher bit densities and also cost effective it is easy to fabricate it is higher-impedance and operational speed all of these
The advantage of MOS devices over bipolar devices is thatit allows higher bit densities and also cost effectiveit is easy to fabricateit is higher-impedance and operation...
go_editor
2.8k
views
go_editor
asked
Jun 12, 2016
Integrated Circuits
isro2008
non-gate
integrated-circuits
+
–
5
votes
1
answer
9
ISRO2007-35
The output $0$ and $1$ level for TTL Logic family is approximately $0.1$ and $5 \text{ V}$ $0.6$ and $3.5 \text{ V}$ $0.9$ and $1.75 \text{ V}$ $-1.75$ and $0.9 \text{ V}$
The output $0$ and $1$ level for TTL Logic family is approximately$0.1$ and $5 \text{ V}$$0.6$ and $3.5 \text{ V}$$0.9$ and $1.75 \text{ V}$$-1.75$ and $0.9 \text{ V}$
go_editor
3.3k
views
go_editor
asked
Jun 10, 2016
Integrated Circuits
isro2007
digital-logic
integrated-circuits
non-gate
+
–
0
votes
0
answers
10
GATE CSE 1994 | Question: 3.10
Match the following items (i) ECL (a) Unipolar; very high speed; difficult to fabricate; good resistance to radiation (ii) Ga As (b) Unipolar; low power; modest speed and packing density (iii) TTL (c) Bipolar; highest speed silicon IC; low packing density (iv) CMOS (d) Bipolar, modest packing density, inexpensive
Match the following items(i) ECL(a) Unipolar; very high speed; difficult to fabricate; good resistance to radiation(ii) Ga As(b) Unipolar; low power; modest speed and pac...
Kathleen
619
views
Kathleen
asked
Oct 5, 2014
Integrated Circuits
gate1994
integrated-circuits
out-of-syllabus-now
+
–
1
votes
1
answer
11
GATE CSE 1998 | Question: 1.15
The threshold level for logic 1 in the TTL family is any voltage above 2.5 V any voltage between 0.8 V and 5.0 V any voltage below 5.0 V any voltage below V$_{cc}$ but above 2.8 V
The threshold level for logic 1 in the TTL family isany voltage above 2.5 Vany voltage between 0.8 V and 5.0 Vany voltage below 5.0 Vany voltage below V$_{cc}$ but above ...
Kathleen
3.0k
views
Kathleen
asked
Sep 25, 2014
Digital Logic
gate1998
digital-logic
integrated-circuits
out-of-syllabus-now
+
–
6
votes
3
answers
12
GATE CSE 1991 | Question: 03,i
Choose the correct alternatives (more than one may be correct) and write the corresponding letters only: (i). The advantages of CMOS technology over a MOS is: (A). lower power dissipation (B). greater speed (C). smaller chip size (D). fewer masks for fabrication (E). none of the above
Choose the correct alternatives (more than one may be correct) and write the corresponding letters only:(i). The advantages of CMOS technology over a MOS is:(A). lower po...
Kathleen
1.7k
views
Kathleen
asked
Sep 12, 2014
Digital Logic
gate1991
digital-logic
integrated-circuits
out-of-gate-syllabus
+
–
To see more, click for the
full list of questions
or
popular tags
.
Email or Username
Show
Hide
Password
I forgot my password
Remember
Log in
Register